CONTROLS

• Termites
• Wood-Destroying Insects
• Decay Fungi

PenaShield is a ready-to-use product.

PenaShield is applied to wood and is particularly suited for use in situations where odor, chemical sensitivity and environmental contamination are of concern. PenaShield will both eliminate and prevent infestations of wood destroying insects, such as subterranean and drywood termites, wood boring beetles, carpenter ants and decay fungi.

Preserves/Protects Wood and Prevents Wood Decay (Wet and Dry Rot) to Wood Structures and Materials as well as wood Components of Homes, Apartment Buildings, Cabins, Log Homes, Outbuildings (Barns, Sheds, Coops, Garages, etc.), Office Buildings, Decks, Fences, Flooring, Gazebos, Furniture, Cabinets, Shelves, Doors, Handrails, Picnic Shelters, Bath Houses, Saunas, Logs, Beams, Timber, Dimensional Lumber, Plywood, Paneling, etc..

PenaShield eliminates existing infestations and provides long-term protection against wood destroying organisms such as:

• Wood Rot • Decay Fungi • Anobiid Beetles • Old House Borers • Longhorn Beetles • Carpenter Ants • Subterranean Termites • Drywood Termites • Powderpost Beetles .

Apply PenaShield only to bare wood or to wood surfaces where an intact water-repellent barrier is not present.

PenaShield may be brush applied directly from the container or applied with a low-pressure garden-type sprayer. Small wooden items may also be treated by dipping. Return unused product to original container and seal tightly. Always clean and/or flush equipment and lines with water after use. When applying more than one coat, wait at least 20 minutes between applications. No immersion or dip soaking necessary.

Apply PenaShield every 1 to 5 years to exterior unfinished bare wood surfaces. Interior surface treatments of existing wood are considered permanent and do not require reapplication or coating except in situations involving repeated moisture contact or high humidity, such as shower stalls, bathhouses, saunas, etc. Any additional installed wood must be treated. Protection may be extended by coating/painting treated wood with a water-resistant finish such as paint or exterior stain. Although a wide variety of paints and stains have been successfully used over PenaShield treated wood, it is always a good idea to coat a small section of treated wood with the finish to be used and check for compatibility prior to complete application. Allow PenaShield treated wood to completely dry (at least 24 hours) before applying any protective finish and apply protective finish within two (2) weeks of treatment.

PenaShield Kills & Prevents Termites, Carpenter Ants, Wood Boring Beetles and Wood Decay

Apply PenaShield to All Untreated Bare Wood Surfaces!